Sterling Plumbing Harrier 48 User Manual

OWNER'S HANDBOOKHarrier 48CODE480D 481D(English Version)CODE SERIAL NO. HANDBOOK: 111-0436 (Rev.A.)480D 250000001481D 250000001Issue : 24.

Do not tilt the mower when starting the engine.Do not put hands or feet near or under rotating parts.Never pick up or carry the mower while the engine

Allow the engine to cool before storing in any enclosure. To reduce thefire hazard, keep the engine and the surrounding deck area free ofgrass, leaves

Remove the mower from the packaging and check that the followingitems have been supplied correctly. If any items are missing contact,your local Hayter

To prevent engine damage the engine is shipped without oil orpetrol. The engine must be filled with the correct grade of oil andpetrol before startin

Operate all control levers several times and ensure that the cablesmove freely. Check that the engine stop and ground drive clutch leversreturn freely

(481 Only) - Stand behind the mower and hold the handlebar togetherwith the engine stop lever. Turn the ignition key in a clockwise direc-tion and ho

To prevent engine damage do not use the mower on slopes greaterthan 20 degrees.Move the height of cut lever sideways to disengage it from the lockingn

Remove the grassbag and operate the mower with the rear deflector inthe closed position.Areas of heavy growth should be mown without collecting the cl

There is very little work to do this month apart from brushing awayleaves. Keep off the grass if frozen or waterlogged.Rake the grass thoroughly. Spik

Keep mowing regularly and watering as necessary. Fill any crackscaused by drought with a mixture of sharp sand and soil. In dry weath-er conditions le

1.22C481C02ABRIGGS & STRATTONHARRIER12345678910111213141516171918MODEL CODE 480 CODE 481Engine Briggs & Stratton Briggs & Stratton Quantu

To prevent accidents stop the engine disconnect the spark pluglead before attempting to carry out maintenance procedures onthe mower.Follow the hourly

To prevent accidents stop the engine disconnect the spark pluglead before attempting to carry out maintenance procedures onthe mower.1. Air Filter2. F

Check the oil level daily before starting the engine and ensure that thecorrect oil level is maintained. Refer to-‘Before Starting the Mower’for oil c

Use only Briggs & Stratton spark tester (1) to check for a spark asshown in the diagram.Replace the spark plug every 100 hours or every season, wh

Remove grass debris from the top and underside of the deck housingimmediately after use.To prevent accidents fertilisers and top dressings are particu

Lubricate the wheels, pivot points and linkages with engine oil every 25operating hours.Apply a good quality medium grease to the inner control cables

Assemble the cutterblade with the turned up edges facing towards theengine. Secure the cutterblade using the bolt (1), spring washer (2), anddistance

To store the handlebar unscrew the 2 small securing knobs sufficient-ly to allow it to be pivoted forwards to rest against the mower. Takecare to ens

PREVENT ACCIDENTS: ALWAYS charge the battery in a wellventilated area. NEVER charge the battery near naked flames or direct heat. ALWAYS switch off t

PROBLEM POSSIBLE FAULT REMEDYEngine will not turn over Engine stop lever released. Operate engine stop lever.Incorrect oil level. Check oil level.Obst

1ST Year (12 months)We certify that this service has been carried out by an Authorised HayterService DealerDate:1ST Year (12 months)Owner’s Name:Seria

Incorrect/contaminated fuel. Drain tank and fill with correct fuel.PROBLEM POSSIBLE FAULT REMEDYEngine vibrates excessively Mounting bolts loose. Tigh

1.31CONFORMITYOFDECLARATIONEC DECLARATION OF CONFORMITYHAYTER LIMITED, Spellbrook, Bishopʼs Stortford, Herts CM23 4BU ENGLANDdeclare that the lawnmowe

DESCRIPTION PART NO. ITEM NOTE1 Mainframe - Casting 480010V 1 12 Plate - Location RH 480083V 1 13 Clamp - Bo

DESCRIPTION PART NO. ITEM NOTE40 Cover - APTO 480014 1 141 Bearing - APTO 480050 1 142 Screw - Washer Hd Ta

DESCRIPTION PART NO. ITEM NOTE83 Washer - Spring 09273 1 184 Bolt - UNF 09121 1 185 Distance Piece - Cutterb

10110311310910410511453107107108BRIGGS & STRATTONHARRIER41359847344C481D01A12334497975567891010111112100100361399992314151616181919202122710224252

1.36INFORMATION/NOTESCUSTOMERNotes:-Serial No:Engine Type:-12G882-1515-21 Engine:-Briggs & Stratton Quantum XTS-50-ICEngine Type:-12L887-1562-2

111-0436 (A) 27/10/05 12:57 pm Page 1.4

1.20 Maintenance Schedule1.20 - First 5Hrs1.20 - Daily1.20 - 25 Hrs or Every Season1.20 - 50 Hrs or Every Season1.20 - 100 Hrs or Every Season1.21 -

Thank you for purchasing a Hayter mower. The following pages are designed to help you gainsafe and efficient service from your machine.IMPORTANT: Thi

1.7WARRANTYLIMITED WARRANTYHayter Limited warrants to the original user/purchaser that this unit shall be free from defectsin material and workmanship

This safety alert symbol indicates important safety messages. Whenyou see this symbol be alert to the possibility of injury. Carefully readthe followi

- Always use fresh fuel. Stale fuel can block the carburettor and causeleakage.- Replace fuel tank and oil tank caps securely.A damaged cutterblade or